I've been playing around a little with the idea of printing a Quadrotor frame. So I was browsing around on Thingiverse when I stumbled upon this design: http://www.thingiverse.com/thing:34552. I used that as a basis for my own design but changed a few things. I made the spacer from the arms a separate part, this because I didn't have long enough screws so I embedded a M3 spacer inside it so I could screw it from both sides. Also I changed so it could take the motor I have been thinking of using, made it higher to fit a battery in between the plates and added small feet.
And some pictures!
Concept design
Test with one boom
Test with one boom
Zoomed on the split spacer with an M3 hex-spacer inside
No comments:
Post a Comment